Water Heaters

Share & Bookmark, Press Enter to show all options, press Tab go to next option
Print

General Information

A permit is required for the installation of all water heaters.

State law allows a homeowner to perform this work on their homestead. However, any other person performing this work must be a licensed plumber registered as a contractor with the City of Carrollton.


Gas Water Heaters
1. Upper and lower combustion air must be installed when a water heater is installed in a closet area.
2. There must be a 1" clearance on water heater vent from all combustible materials and manufacturer’s specifications must be observed.
3. The gas stop must be ball valve type that can be shut off by hand.
4. The maximum length of flex gas pipe is 36", ½" minimum size.
5. Carbon monoxide alarm shall be installed outside each separate sleeping area.

All Water Heaters
1. There must be an expansion tank for thermal expansion protection installed on cold water pipe.
2. Water heater pan must be approved for application.
3. There must be in a 1½" deep pan with a ¾" drain line to outside or approved receptor.
4. If installed in garages and attics, water pipes must be insulated.
5. If it is structurally impossible to install a drain line to the outside, then the pan requires a fitting attachment that connects to a water hose, and this fitting must be capped or to the lowest point of the garage floor.
6. The pressure relief valve discharge pipe shall discharge outside not more than 2' nor less than 6" above ground/floor level or into an approved indirect waste receptor.
7. There must be an isolation valve on cold water pipe of heater to shut off water.
8. There must be a cold water electrical ground wire and clamp secured to pipe ahead of shut off valve.
9. There must be unions on water inlet, outlet, temperature, and pressure discharge lines (nut on water flex constitutes a union).
10. If installed in garage, there must be pan drain pipes to floor or outside.



Inspections

An inspection needs to be scheduled upon completion of work. See here for Inspection Guidelines.

Fees and Applications

Applications are accepted through the CityServe Portal along with the permit fee.  Please call 972-466-3225 with any questions.